Safe to Install
PowerBridge Solution is designed as a plug-in electrical appliance to an existing grounded A/C outlet or surge protector.
During installation, you will never have or be in direct contact with electricity or live electrical circuits, you’re totally safe.
PowerBridge is direct wired only between the POWER INLET and POWER OUTLET wall plates.
NO direct connection of electrical wiring to, or, from the electrical circuit, back of an existing outlet or house power panel. It’s safe and easy to install, in your own home. You do not need to be an electrician to make wire connections and plug in a power cord.
After the wall plates are installed, the POWER OUTLET receptacle is energized by simply plugging in the supplied Power Connection Cord female end to the POWER INLET and the male end to the A/C power source, such as a surge protector or nearby existing A/C outlet.
Easy to Install
At the same time while running the A/V cables between the HDTV and source equipment, running in-wall rated power wire, known as ROMEX®, between the POWER INLET and POWER OUTLET and making simple and secure connections.
Your PowerBridge kit comes with a minimum length of pre-stripped 6-foot length ROMEX* wire, easy to follow instructions, with pictures, and wall cut-out template for retro-fit into drywall.
Basic tools are all you need. Pencil, Small level, Drywall saw or sharp utility knife, flat blade screwdriver to install.
* Longer lengths up to 24-feet are available to add to your order.
Important Installation Note
PowerBridge is a recessed in-wall design to allow for low profile wall mounting.
PowerBridge will not mount within shallow walls. If you have fir-stripped over concrete walls, recessed receptacles will not work unless the wall is built out or shimmed to allow the necessary depth.
Most standard constructed walls will have 2×4 wood studs, some 2×6.
Either interior or exterior walls with or without insulation will work with PowerBridge recessed products.